Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
litespeed_wiki:lisa-temp [2018/07/18 14:22] Lisa Clarke [Step 3. Verify] |
litespeed_wiki:lisa-temp [2018/07/18 14:22] Lisa Clarke [Step 4. Check Correct IP is Set] |
||
|---|---|---|---|
| Line 66: | Line 66: | ||
| ==== Step 4. Check Correct IP is Set ==== | ==== Step 4. Check Correct IP is Set ==== | ||
| - | You can check source IP via LiteSpeed default php page ''%%http://yourdomain/index.php?act=phpinfo%%''. Check the ''%%$_SERVER%%'' variables, and look for the ones which begin with ''%%GEOIP_%%''. {{https://openlitespeed.org/wp-content/uploads/2018/07/geoenv.jpg?533x235}} The environment variables are based on the default environment definitions. The advanced section below shows you how to customize them for your environment to allow you to specify environment names, display language, additional databases, etc. | + | You can check source IP via LiteSpeed default php page ''%%http://yourdomain/index.php?act=phpinfo%%''. Check the ''%%$_SERVER%%'' variables, and look for the ones which begin with ''%%GEOIP_%%''. |
| + | |||
| + | {{https://openlitespeed.org/wp-content/uploads/2018/07/geoenv.jpg?533x235}} | ||
| + | |||
| + | The environment variables are based on the default environment definitions. The advanced section below shows you how to customize them for your environment to allow you to specify environment names, display language, additional databases, etc. | ||
| ==== Step 5. Check DB by Lookup Command ==== | ==== Step 5. Check DB by Lookup Command ==== | ||